dirna Bergstrom bycool green line COMPACT 1.4 Mode D'emploi page 25

COMPACT
Position the most suitable console for the
12
vehicle model and align the unit in the most
appropriate part of the cabin roof. Once
aligned, remove the console.
Caution: When choosing the console (*), cut
the (4) indicated nubs so they are flush with
the console.
Fasten supports tightening nuts until outside
13
EPDM joint of equipment is compressed,
between 3 and 6 mm;
Important: To avoid water from filtering inside
cabin, check EPDM joint tightening with unit
base, as indicated on diagram.
3-6mm.
Techo cabina
Fasten selflocked nut until
EPDM gasket is compressed
13
between 3 and 6 mm.
*
EPDM gasket
10 mm*
(*) (approx. after tightening)
12
Base
Bracket
25
Check compression
thickness using a
tape measure in the
four corners.
EPDM gasket
EN
®
13