3M Graco 50261 Manuel D'instructions page 4

Installing 3M ™ Paint Preparation System (PPS)
Paint
cup
Locking
Collar
1. Weigh paint in the cup with liner according to paint manufacturer's
instructions before mixing product.
Fig. 4
2. Mix product as needed.
3. Take the lid (with built in strainer) and snap onto the top of
PPS cup.
4. Position locking collar onto the PPS cup and turn until tight.
5. With spray gun inverted, lower onto PPS cup and lock gun
adapter, turning clockwise, to lid.
6. Make sure that the lid fingers are fully engaged above
adapter edge.
Fig. 6
Setup
Paint
cup liner
200
Micron
Strainer
Paint
cup lid
Sealing
Cap
Fig. 5
7. With air line connected, invert gun and pull trigger (fully open
NOT partially) to bleed air from the liner.
to be bled if spraying in the inverted position.
Fig. 7
8. With the air removed from the liner, the gun may be sprayed
upside down or in any direction to reach difficult areas.
Fig. 8
PRESSURIZED EQUIPMENT HAZARD
To reduce the risk of a serious injury whenever you are instructed to
relieve pressure, follow the Pressure Relief Procedure
Positioning the Air Cap
Rotate the air cap as needed to achieve the
direction. To create a round pattern, turn the pattern air off by turning
the pattern adjustment knob (25) fully clockwise. Refer to Fig. 11.
Fig. 9
4
NOTE: Air only needs
WARNING
on page 6.
desired spray pattern
ertical atter
Horizo tal atter