Accessories; Dimensions; Technical Data - 3M Graco 50261 Manuel D'instructions

Accessories

HVLP Models
Air Pressure Verification Kit 50280
For use in checking air cap atomizing air
Not to be used for actual spraying.
Install the kit air cap on the gun.
gun, then trigger the gun and read the air pressure on
the gauge.
NOTE: To be 'HVLP compliant', the atomizing air
pressure must not exceed 70 kPa, 0.7 bar (10 psi).

Dimensions

193 mm
(7.6 in)
pressure.
Turn on the air to the
170 mm
(6.7 in)

Technical Data

Category
Maximum Working AIr Pressure
Maximum Inbound
Air Pressure
Maximum Outbound
Air Pressure
Air Consumption
Fluid and Air Operating
Temperature Range
Weight
Air Inlet
Wetted Parts
Noise Data*
Sound Pressure
Sound Power
* All readings were taken with the gun controls fully open and
with 280 kPa, 2.8 bar (40 psi). Sound pressure was tested to
CAGI-PNUEROP-1969. Sound power was tested to ISO 3744-1981.
15
Data
0.7 MPa, 7 bar (100 psi)
HVLP and Compliant Spray Guns
Should not exceed 200 kPa,
2.0 bar (29 psi)
HVLP Only
Should not exceed 70 kPa,
0.7 bar (10 psi) at the Air Cap
HVLP at 200 kPa, 2.0 bar
(29 psi) = 439 l/min or 15.5 scfm
Compliant at 200 kPa, 2.0 bar
(29 psi) = 317 l/min or 11.2 scfm
Airspray at 345 kPa, 3.4 bar
(50 psi) = 399 l/min or 14.1 scfm
0°C to 43°C (32°F to 109°F)
632 g (22.3 oz.)
1/4 - 18 npsm
304 and 303 Stainless Steel,
PEEK, Acetal, Ultra High
Molecular Weight Polyethylene
84.4 Db(A)
94.0 Db(A)