Parking The Vehicle - Kärcher MIC D Mode D'emploi

6.1.11 Preselection of the speed (MDC variant)
6.1.12 Driving
ATTENTION
Let the motor warm up sufficiently prior to driving or

loading the vehicle.
6.1.13 Stop
Release the drive pedal, the machine brakes automat-

ically and stops.
6.1.14 Driving over obstacles
CAUTION
Risk of damage!
Ensure that the vehicle does not ground.

Obstacles up to 150 mm in height:
6.1.15 Driving on public roads

6.1.16 Parking the vehicle

Stop vehicle.

Apply parking brake (with MDC variant).

Travel direction selector switch to NEUTRAL position -

central position (not with MDC variant).
Set the accelerator lever to low motor speed / hand

throttle position.
Let the engine idle for 1 to 2 minutes.

Turn ignition key to "STOP" and remove it.

Turn the main switch to position 0.

1 TRANSPORT MODE FAST:
2 TRANSPORT MODE SLOW:
3 Lever for preselection of the speed
The preselection of the speed must only be performed at a
standstill of the vehicle.
Stop vehicle.

Set the accelerator lever to low motor speed / hand

throttle position.
Select the desired speed at the lever (on the right side

of the console).
1 TRANSPORT MODE FAST:
The drive speed is regulated via the drive pedal; max.
30 km/h.
2 TRANSPORT MODE SLOW:
The driving speed is regulated via the accelerator ped-
al. Max. speed approx. 15 km/h.
During transport drives, use the drive pedal carefully,

because there is a risk of sudden speed decrease!
For a stronger braking effect or in case of an emergen-

cy, actuate the brake pedal.
Bypass the obstacles slowly and carefully at an angle

of 45°.
Obstacles more than 150 mm in height:
Only drive over these obstacles using a suitable ramp.

When driving on public roads for transport purposes (not
during cleaning of public roads), the hydraulics of the at-
tachments must be locked in order to prevent accidental
movements of the attachments.
Raise attachments.

Switch off PTO.

Turn the rotary knob for the lowering speed in a clock-

wise direction (direction B) to the stop in order to lock
the front power lift.
Set the accelerator lever to low motor speed / hand

throttle position.
Select desired transport mode.

26
-
EN 83