Beko MWOTR 30200 CSS Manuel D'utilisation page 25

Installation
5
B5. Adapting microwave blower for
outside back exhaust
1. Remove and save screw that holds blower
motor to microwave.
Blower Motor
2. Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
Before: Fan Blade
Openings Facing
Forward
End A
3. Roll the blower unit 90°
Before Rotation
Back of
Microwave
Over The Range Convection Microwave Oven / Installation Manual
4. Rotate blower unit counterclockwise 180°.
Back of
Microwave
Blower Motor
5. Gently remove the wires from the grooves.
Screw
Reroute the wires through grooves on other
side of the blower unit.
End B
Wires Routed Through Right Side
6. Roll the blower unit 90° so that fan blade
openings are facing out the back of the
microwave.
After Rotation
Back of
7. Remove the knockout plates in the back of the
Microwave
unit with snips.
Before Rotation
Back of
Microwave
Before Rerouting
Wires Routed Through Left Side
Before Rolling
Back of
Microwave
Back of mircrowave
After Rotation
Back of
Microwave
After Rerouting
After Rolling
Back of
Microwave
Knockout Plates:
Snip all 4 webs on
each knockout panel
and remove the metal
knockouts for rear air ow.
Please take care to
remove any sharp edges
created from removing
the knockout plates.
25 / 63 EN