Beko MWOTR 30200 CSS Manuel D'utilisation page 19

Installation
5
A3. Adapting microwave blower for
outside top exhaust
1. Place the microwave in its upright position, with
the top of the unit facing up. Remove the screw
that holds the blower plate to the microwave.
Remove and save the screw holding the blower
motor to the microwave.
2. Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
End A
3. Roll the blower unit 90° so that fan blade
openings are facing out the top of the
microwave.
Before Rotation
Back of
Microwave
Over The Range Convection Microwave Oven / Installation Manual
4. Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing
Blower Plate
Back of
Microwave
5. Secure blower unit to microwave with the screw
Blower Motor
6. Replace blower plate with the screw removed in
Screw
End B
7. Attach the exhaust adaptor to the top of the
Back of
Microwave
After Rotation
Back of
Microwave
Top
removed in Step 1. Make sure the screw is tight.
Step 1. Make sure the screw is tight.
blower plate by sliding it into the guides of
the blower plate. Push in securely until it is in
the locking tabs. Take care to assure that the
damper hinge is installed so that the damper
swings freely.
Adaptor
Guide
Locking Tab
Back of
Microwave
Back of
Microwave
Back of
Microwave
19 / 63 EN