Dometic SKYSOL POWERED ROOFBLIND Instructions De Montage page 25

Powered Roofblind
If fitting a curved frame position the blind vertically using the side track
screws rather than the corner screws.
7.3.3 Connecting the motor
➤ Connect the motor as shown:
– Manually switched blinds (fig. 7, page 6).
– Remotely controlled blinds (fig. 8, page 6) or
– Using other control system (fig. 9, page 7)
7.3.4 Moving rail fitting
➤ Proceed as shown (fig. 0, page 8).
Dependent on the version the blind is equipped with one or two moving
rails.
7.3.5 Blind panel fitting
A
NOTICE! Risk of damage
Ensure that the cording on each panel is routed correctly (fig. b, page 9).
Always extend the fabric panels completely before clipping them in. This pulls
the cords tight and prevents them from dropping and potentially getting
trapped when being clipped in.
I
NOTE
• Connect the power and drive the moving rail away from the head rail before
you start fitting the panels (fig. c, page 9, step 1.). There is not enough
space to fit the panels with the shoes in the shipped position.
• Check whether the moving rail is square and moves freely before fitting any
of the other panels. If the moving rail is not square it can be adjusted as
shown (fig. a, page 8).
➤ Clip the fabric panel to the shoes (fig. c, page 9, steps 2., 3. and 4.).
➤ Connect a Fabric 1 blind panel to the moving rail (fig. d, page 10, steps 1.,
2. and 3.).
➤ Clip the next fabric panel to the shoes in the side tracks.
➤ Extend the fabric panel to ensure the cords do not drop (fig. d, page 10,
step 4.).
➤ Clip the second fabric panel to the first fabric panel (fig. d, page 10,
steps 5. and 6.).
➤ Repeat the process for all panels (fig. d, page 10).
➤ Power the blind to move all fabric panels towards the head rail (fig. e,
page 10)
EN
Installation
25