Startup - Storch Airless ST 2000 Mode D'emploi

9. Place the intake pipe in earthed metal pail partially fil-
led with flushing fluid. Attach ground wire to pail and to
true earth ground. Perform steps 1 - 5 of Startup to flush
out bearing oil shipped in the sprayer. Use water to flush
water-base paint and mineral spirits to flush oil-base
paint and storage oil.
Original instruction

Startup

1. Perform Pressure Relief Procedure.
2. Turn pressure control to lowest pressure.
3. Turn power on.
4. Increase pressure 1/2 turn to start motor and allow
fluid to circulate through the circulation hose for 15
seconds; then turn the pressure control back to the lowest
value.
5. Turn circulation switch forward to SPRAY position.
Disengage trigger lock.
170 Original instruction