Function Menu; Menus Description - Beninca IRI.KPAD Mode D'emploi

3) FUNCTION MENU

After activating the keypad, and typing the access password followed by #,
access is enabled to the Function Menu (2 beeps are heard from the buzzer).
IRI.KPAD awaits that one of the 9 Menu available is selected. During this dwell time,
a beep every 0.5sec is heard:
N. Function
1 Change of access password for programming menu
2 Entering an Administrator PIN
3 Entering a User PIN (advanced function)
4 Cancellation of a PIN
5 Entering down counter (advanced function)
6 Configuration Menu of operation
7 Configuration Menu of proximity switch
8 Verification menu of the type of encoding of a stored PIN
9 Enable Menu of # button for code repetition.
Press the desired menu button.
NOTE:
• The keypad is activated by pressing any key.
• Auto shut-off is 10 seconds. After this period of time the system must be switched
on again, as described above.
• To exit a programming menu without making any changes, press #, or wait for
20 seconds (time-out time).
• A possible programming error is indicated with a long beep, IRI.KPAD then exits
the programming phase.

MENUS DESCRIPTION:

MENU 1 (TO CUSTOMIZE THE ACCESS PASSWORD)
After typing key 1, the customization of the password phase is entered, indicated
by 2 beeps followed by an interval.
- Type in the new password (6 digit) and press #.
- IRI.KPAD confirms the typing with 3 beeps followed by an interval.
- Type in the new password once more and press #.
- If the two digits are the same the password is stored in memory and the keypad
returns to stand-by mode.
MENU 2 (TYPING IN OF ADMINISTRATOR PIN)
After typing key 2, the customization of the Administrator PIN code is entered, indicated by
2 beeps followed by an interval. The Administrator PIN can be composed of 1 to 9 digits.
- Type in the Administrator PIN and press #.
3 beeps, followed by an interval, are heard to confirm the operation.
22