Dolmar RM-72.13 H Manuel D'utilisation page 78

Masquer les pouces Voir aussi pour RM-72.13 H:
Table des Matières
Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
MAINTENANCE
B
ATTERY
To ensure long life to the battery it is essential to keep it carefully maintained.
The machine battery must always be charged:
– before using the machine for the first time after purchase;
– before leaving the machine for a prolonged period of disuse;
– before starting up the machine after a prolonged period of disuse.
– Carefully read and comply with the procedure for recharging described in the
booklet coming with the battery. If the procedure is not followed or the battery is
not charged, irreparable damage could be caused to the elements inside the
battery.
– A flat battery must be recharged as soon as possible.
IMPORTANT
stant voltage. Other recharging systems can irreversibly damage the battery.
The machine has a connector (1) for
recharging, to be connected to the corre-
sponding connector of the special "CB01"
maintenance battery-charger supplied
(
if included) or available on request
(chapter 8).
IMPORTANT
only be used for connection to the "CB01" maintenance battery-charger. For its
use:
– follow the instructions given in the relative instruction booklet,
– follow the instructions given in the battery booklet.
E
LECTRICAL SYSTEM
The electronic card and the electrical sys-
tem are protected by:
– a self-resetting device which breaks the
circuit when there is a function fault, and
is accompanied by an audible signal
which continues until the key is
Recharging must be done using a battery charger at con-
This connector must
1
EN 31
1
(6.3 Amp)
Table des Matières
loading

Table des Matières