Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. ALARM CLOCK
5.1
Introduction:
You may program an alarm (wake-up) time in the WS-5300.
You may then also enable a frost alert; when the outdoor temperature falls below -3°C, the wake-up signal
will sound 30 minutes before the set wake-up time.
5.2
To set the alarm time:
1. press and hold the
flashing
2. use
/
to set the hours and then briefly press
3. use
/
to set the minutes and then briefly press
5.3
To set the alarm function:
1. press the
button once or several times to check the alarm or to switch it on/off
Only "AL" appears: the time being displayed is the set alarm time, but the alarm itself is switched off
"AL" + " " illuminates: the alarm is switched on and the wake-up signal will sound at the set alarm time
"AL" + " " + " " appears: the frost alert is set
2. release the
to the above description, remains visible
5.4 Operation:
•
At the set time, the alarm will sound for up to 120 seconds
•
For the first 4 seconds, the alarm signal has a slow rhythm
•
Between 4 and 8 seconds, the rhythm of the alarm signal increases
•
Between 9 and 12 seconds, the rhythm of the alarm signal increases further
•
After 13 seconds, the rhythm of the alarm signal is the fastest
•
Press the
button to stop the alarm signal beforehand OR press the SNOOZE button on top of the
weather station to enable the snooze function; the wake-alarm will then sound again after 5 minutes
•
The alarm is repeated daily unless you disable it according to the above instructions.
•
If you've enabled the frost alert " " and the outdoor temperature falls below -3°C, the wake-up signal will
sound 30 minutes earlier than the time you've set. If the outdoor temperature is above -3°C, the alarm
will sound at the set time.
6. HISTORY
6.1
Introduction:
The weather station of the WS-5300 automatically stores all measurement data of the past 24 hours to
allow you to check the trend of the past 24 hours at any moment
6.2
To view historic data:
1. press the HISTORY button, the most recently stored measurement data is shown in the display includ-
ing the time and date of the concerned data in the upper part of the display
2. repeatedly press the HISTORY button to scroll the memory
The data of the indoor and outdoor temperature and humidity, air pressure, wind chill, wind speed and
rainfall is saved in the history memory.
6.3
To delete historic data:
Press and hold the HISTORY button for 10 seconds to erase all measurement data up to that moment.
button at the rear of the weather station for 2 seconds until the hour digits start
button, after several seconds the actual time is displayed and the alarm status, according
; the minute digits start flashing
; the alarm time is now set
55
Publicité
Table des Matières
