Max-Min Alert; Introduction; Hi-Lo Limits Setup; Hi-Lo Alert Function Setup - Alecto WS-4900 Mode D'emploi

5. MAX-MIN ALERT

5.1 Introduction:

You may set an alert for the following measurements when a maximum or minimum value is being exceeded:
Indoor temperature
Indoor humidity
Outdoor temperature
Outdoor humidity
Rainfall
Wind speed

5.2 Hi-Lo limits setup:

1. Press the
AL' (whatever applies)
2. Use / to set the limit value
3. Briefly press the
4. Press the
automatically

5.3 Hi-Lo alert function setup:

1. Press the
AL' (whatever applies)
2. Briefly press the

5.4 Operation:

As soon as the set limit is exceeded, an alert will sound for up to 2 minutes while the concerned value starts
flashing. You may stop the alert sound by briefly pressing the ALARM/ SNOOZE button. The concerned
measurement value automatically stops flashing when it returns to within the set limit (or as soon as you
adjust the limit or switch off the alert function for this measurement).

6. ALARM CLOCK

6.1 Introduction:
You may program an alarm (wake-up) time in the WS-4900.
You may then also enable a frost alert: when the outdoor temperature falls below -3°C, the wake-up signal
will sound 30 minutes before the set wake-up time.

6.2 To set the alarm time:

1. Press and hold the
flashing
2. Use / to set the hours and then briefly press , the minute digits start flashing
3. Use / to set the minutes and then briefly press , the alarm time is now set
Attention: after setting the alarm time for the first time, this function is enabled directly.

6.3 To set the alarm function:

1. Press the button once or several times to check the alarm or to switch it on/off
Only "AL" appears:
"AL" + " " appears:
"AL" + " " + " " appears: the frost alert is set
2. Release the
to the above description, remains visible
min/max alert
min/max alert
min/max alert
min/max alert
max alert (only the actual amount of rainfall as off 12:00am is considered)
max alert
button once or repeatedly until the desired display starts flashing followed by 'HI AL' or 'LO
button to save the value
button again to go to the next value or wait several seconds until the settings are closed
button once or repeatedly until the desired display starts flashing followed by 'HI AL' or 'LO
button to switch this alert on or off.
button at the rear of the weather station for 2 seconds until the hour digits start
the time being displayed is the set alarm time, but the alarm itself is switched
off
the alarm is switched on and the wake-up signal will sound at the set alarm
time
button, after several seconds the actual time is displayed and the alarm status, according
67