Wake-Up Alarm; Weather Alert; Weather Forecast - Alecto WS-5500 Mode D'emploi

7.4 Wake-up alarm:

Setup:
1. press and hold the ALARM button for 2 seconds, the hour display
starts flashing
2. use the + and - buttons to set the hours for the wake-up time and press
the SET button
3. use the + and - buttons to set the minutes for the wake-up time and
press the SET button
4. briefly press the ALARM button to enable (alarm icon illuminates) or
disable (alarm icon off) the wake-up alarm
5. briefly press the LIGHT/SNOOZE button to leave the setup
Operation:
As soon as the set moment of time is reached, an alarm tone is emitted.
This tone sounds for approx. 2 minutes with an increasing rhythm or un-
til you press the ALARM button to switch off the alarm or until you press
the LIGHT/SNOOZE button to postpone the alarm for 10 minutes.
The alarm is repeated daily until disabled according to the above
instructions.

7.5 Weather alert:

In addition to the wake-up alarm with snooze function, this weather
station can also emit an alert tone when temperatures are too high/low,
when the humidity is too high/low or in case of excessive wind or rain.
Setup:
1. press and hold the ALARM button for 2 seconds and then repeatedly
and briefly press the SET button to choose from the following alarms:
- max. indoor temperature
- min. indoor temperature
- max. air humidity indoors
- min. air humidity indoors
- max. outdoor temperature
- min. outdoor temperature
- max. air humidity outdoors
- min. air humidity outdoors
- max. wind speed
- max. wind gust
2. use the + and - buttons to set the limit for the selected measurement
value
3. briefly press the ALARM button to enable the concerned weather
alert (the symbol illuminates followed by HI or LO) or to disable it
(the symbol disappears)
Overview:
If an alert is programmed for a certain measurement value, this will be indi-
cated by the alarm symbol being constantly illuminated followed by HI or
LO. When this symbol is flashing, this limit is exceeded, see also 'Operation'
below
In display standby mode, briefly press the ALARM button to show all
programmed maximum limits. Press the ALARM button again to display all
programmed minimum limits. The
limit associated with an alarm.
Press the ALARM button again or press the LIGHT/SNOOZE button to return
the display to standby mode.
Operation:
As soon as one of the limits is exceeded, for 2 minutes alert tones will sound
in an increasingly faster rhythm. The alarm symbol together with HI or LO will
start flashing to show which limit is exceeded.
Press the ALARM button to stop the alert tones, the alarm symbol continues
flashing until the measured value returns to within the set limits.

7.6 Weather forecast:

The display of the indoor unit can predict the weather for the next 6
hours through various displays:
sunny
cloudy
54
alert symbol will also appear for any
partially cloudy
rainy