Alecto WS-5500 Mode D'emploi page 51

Press 1x the SET button:
D-M / M-D Use the + and - buttons to select the day-month
display (D-M) or month-day display (M-D).
Press 1x the SET button:
Use the + and - buttons to set the year.
YEAR FLASHING
Press 1x the SET button:
Use the + and - buttons to set the month.
MONTH FLASHING
Press 1x the SET button:
Use the + and - buttons to set the date.
DAY FLASHING
Press 1x the SET button:
Use the + and - buttons to determine whether the
PRESSURE
air pressure must be shown in mm mercury pres-
sure (mmHg), in inch mercury pressure (inHg) or in
hectoPascal (hPa). In the Benelux the hectoPascal
notation is generally used; before the air pressure
was also expressed in bar; 1 mbar equals 1 hPa.
Press 1x the SET button:
The absolute air pressure is the air pressure
REL PRESSURE
measured by the weather station; the relative
air pressure is the air pressure measured by the
weather station but now corrected for the altitude at
which the measurement is taken.
For this option, use the + and - buttons to set the
actual air pressure.
Tip: you may find the current air pressure in your
area on the website of airports (or on their teletext
pages).
Press 1x the SET button:
LIGHT Use the + or - button to display the light intensity in
W/m² (Watt per m²), fc (foot candle) or LUX.
Press 1x the SET button:
°C / °F Use the + or - button to display the temperature in
degrees Celsius (°C) or in degrees Fahrenheit (°F).
Press 1x the SET button:
WIND Use the + or - button to display the wind speed in
Knots, Miles per hour (mph), Kilometres per hour
(Km/h), Beaufort (bft) or meters per second (m/s).
Press 1x the SET button:
RAIN Use the + or - button to display the amount of rainfall
in millimetre (mm) or inch (IN).
Press 1x the SET button:
NTH / STH Use the + or - button to indicate whether the weather
station is used in the Northern hemisphere of the
earth (NTH) or in the Southern hemisphere (STH).
This concerns the correct display of the moon
position.
Tip: The Benelux is situated in the Northern hemisp-
here, in this case please select NTH.
Upon pressing the SET button for the last time, the display will fully illumi-
nate and the setup is now completed.
During setup, you may press the LIGHT/SNOOZE button to instantly end
the setup. Any settings already adjusted will remain stored in the memory.
*: as soon as the indoor station is connected with the internet (see chap-
ter 8), the time and date are obtained from the internet. Now repeatedly
press the SET button to skip the clock setup.
51