Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.3 Function buttons:

The function buttons underneath the display offer the following func-
tions:
SET
SET
TEMP.
TEMP.
RAIN
RAIN
TEMP.
touch repeatedly to see the following in order:
• CHILL: wind chill (calculated through a combina-
tion of the air temperature and the average wind
velocity).
• DEW: dew point temperature, this is the tempera-
ture at which water vapour is converted into water
(mist, dew or frost); the dew point depends on the
environmental temperature and humidity.
• HEAT: heat index, this is a combination of the
measured temperature and the humidity.
When no extra specification is shown, the actual
temperature will be displayed.
LIGHT
WIND
PRESSURE
ALARM
ALARM
ALARM
MAX/MIN
MAX/MIN
MAX/MIN
_
SNOOZE
+
RAIN
touch repeatedly to see the following in order:
• DAY: rainfall of today, calculated as of midnight
• WEEK: rainfall from the beginning of the week
(Sunday)
• MONTH: rainfall from the beginning of the month
• TOTAL: rainfall from the start of the measure-
ments or from the last reset
• RATE: rainfall in the past hour (this shows the
rainfall in the last 60 minutes and is updated every
10 minutes)
• EVENT: this is the amount of rainfall from the
moment it started raining until now. This value will
be reset after an hour without any rain.
Press and hold the RAIN button for 2 seconds to
reset the display of that moment to 0.
When doing so, keep in mind the following:
- when resetting the amount of rainfall per week, also
the amount of today will be reset
- when resetting the amount of rain per month, also
the amount of today and of this week will be reset
- when resetting the total amount of rainfall, also the
amount of today, this week and this month will be
reset
WIND / +
touch repeatedly to see the following in order:
• GUST: wind speed of wind gusts
• DIRECTION: wind direction in arc degrees
When no extra specification is shown, the actual
temperature will be displayed.
During setup (see paragraph 7.2), this button is also
used for selecting choices and increasing values
52

Publicité

Table des Matières
loading

Table des Matières