To Set The Relative Air Pressure - Alecto WS-5300 Guide De L'utilisateur

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

7. MAX/MIN MEMORY FUNCTION

7.1

Introduction:

For the following measurement you may view the maximum and minimum value measured. The display will

indicate the time of the measured value. Functions indicated with "alarm" also have a Hi and/or Lo alarm.

When the actual value becomes lower or higher than the set alert value, an alarm will sound while the or-

ange LED at the front starts flashing.

Indoor temperature

Indoor humidity

Outdoor temperature

Outdoor humidity

Wind chill

Wind heat index

Indoor dew point

air pressure

Wind speed

Wind average

Wind gust

Rainfall

7.2

To set the Hi-Lo limits:

1. press the

button once or several times until the desired display starts flashing followed by 'HI AL' or

'LO AL' (if applicable)

2. use

to set the limit

3. briefly press the

4. press the

button again to skip to the following display or wait several seconds until the setup is ended

automatically

7.3

To set the Hi-Lo alert function:

1. press the

button once or several times until the desired display starts flashing followed by 'HI AL' or

'LO AL' (if applicable)

2. briefly press the

7.4

Operation:

As soon as the set limit is exceeded, an alert will sound for up to 2 minutes while also the concerned display

and the orange LED are flashing in the display. You may stop this alert by briefly pressing the "SNOOZE" or

button. The flashing stops automatically as soon as the concerned measurement value returns to within

the set limits (or as soon as you adjust the limit or disable the alert function for that measurement).

8. RELATIVE AIR PRESSURE

8.1

Introduction:

If you're living in an area considerably higher than sea level, you'll experience a lower air pressure. To have

the device calculate the weather forecast accurately, you must correct the air pressure for this altitude.

8.2