To Reset The Rain Data; General Functions; Moon Phase - Alecto WS-3300 Guide De L'utilisateur

When the snooze function is activated, the alarm will sound again after 5 minutes. The
display. The snooze function can be repeated 7 times.
5.4

TO RESET THE RAIN DATA:

After everything is installed, press and hold the "RAIN CLEAR" (34) button for 2 seconds to delete all
measurement data up to that moment. This prevents you from seeing measurement data at a later time
that was caused by movements during the installation.
6. USE
6.1

GENERAL FUNCTIONS:

The display shows the following basic functions / data:
6.2 CLOCK:
Clock with DCF-77 reception indication.
In the image above the DST logo (daylight saving time) is visible.
Upon receiving the DCF-77 signal, the indicated time is correct.
Briefly press the "MODE/SET" (30) button to view the day, date and alarm time.
6.3

MOON PHASE:

The moon phase indication shows the moon phase by means of an icon.
This allows you to keep track of the moon phase.
The display of the moon phase is linked to the settings of the date, month and year.
The following moon phases may be indicated:
new moon waxing crescent
6.4 BACKLIGHTING:
Press the "SNOOZE/LIGHT" (36) button to switch on the backlighting.
The backlighting will remain on for approximately 5 seconds and will then turn off automatically.
6.5 LOW BATTERY INDICATION:
When the icon appears, the batteries of the outdoor unit are nearly exhausted.
Replace the batteries as soon as possible.
MOON PHASE
first quarter
waxing moon
38
full moon waning moon
icon flashes in the
last quarter ashen moon