Safety Regulations; Additional Safety Instructions; Layout And Items Supplied - EINHELL TC-WW 1000/1 Instructions D'origine

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.

Additional safety instructions

Warning: When using electric tools it is imperati-
ve to take the following basic safety precautions
in order to reduce the risk of electric shock, injury
and fi re. Read and take note of these instructions
before you use this tool.
•
Wear safety goggles and head protection,
e.g. a hard hat.
•
Wear tight-fitting clothes which cannot be-
come caught up in the rotating workpiece.
•
Secure the machine firmly to the surface.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. On/Off switch
2. Front end driver ring
3. Tool support
4. Centering pin
5. Counternut
6. Tailstock
7. Tailstock spindle
8. Hand wheel
9. Machine bed (can be dismantled for trans-
port)
10. Clamping lever
Anl_TC_WW_1000_1_SPK9.indb 17 Anl_TC_WW_1000_1_SPK9.indb 17
GB
11. Plate
12. Locking grip
13. Retaining screw
14. Wrench for pinion shaft
15. Face plate
16. Housing cover
17. Motor tightening screw
18. V-belt pulley
19. V-belt
20. Crank handle
21. Hexagon key
22. Wrench for front end driver ring
23. Screw, small
24. Washer, small
25. Spring washer
26. Nut, small
27. Screw, large
28. Washer, large
29. Wing nut
30. Washer for crank handle
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Wood lathe
•
Front end driver ring
•
Tool support
•
Tailstock
•
Hand wheel
•
Clamping lever (2x)
•
Plate (2x)
- 17 -
06.07.2018 10:29:28 06.07.2018 10:29:28