Usb Connexion; Listening To The Radio; Cassette Operation - AEG SRR 4308 CD/MP3 Mode D'emploi & Garantie

Infrared remote control
This is used for operating the device without a cable from
a distance of up to 5 metres. If the range decreases, the
batteries have to be changed. Please ensure that there is
nothing blocking the direct line of vision between the remote
control and the IR infrared receiver (3) on the device.

USB Connexion (35)

This device has been developed in accordance with the
latest technical developments in the USB fi eld. Unfortu-
nately the large number of different types of USB storage
media on offer today makes it impossible to guarantee full
compatibility with all USB storage media.
• In order to switch on the device please press the
POWER switch (1/36).
• Now press the FUNCTION button (30/42) to select the
CARD-USB mode.
• Connect a USB storage medium.
• Press II (10/46) to play back the music data.
For operating instructions please see the section "Playing
CDs/MP3s".
Note: The FIND function is restricted.

Listening to the Radio

Setting the Stations
1. Switch the device on by pressing the POWER button
(1/36).
2. Use the FUNCTION button (30/42) to select the
TUNER mode in order to activate radio operation. The
display shows the radio frequency and the radio band
on the left
FM (MHz) and MW (KHz) = medium wave.
3. By pressing the BAND button (26/39) again you can
switch to another radio band. If you press the !/ I
TUNING/SKIP button (9/38) or the
SKIP button (9/47) once, you can change the frequency
being received step by step. If the button is kept pressed
down, the fast search function is switched on. The device
starts an automatic station search. As soon as a station
has been found the automatic station search stops.
4. If you have found the desired station, press the PROG/
MEM button (12/40). The word MEMORY lights up and
the station memory number fl ashes.
5. In order to determine the programme storage location,
press the PRE-UP button (15/53) or the
DN button (17/43).
6. To store this position, press the PROG/MEM button
(12/40). Please note that the programme storage
location must be entered within fi ve seconds as the
procedure is then cancelled.
05-SRR 4308 CD AEG New 55
To select a stored station press the
PRE-DN button. With the help of the numerical keys
you can select the desired station memory number.
Example: In order to play the station stored under 05
fi rst press the 0 numerical key - the fi gure "0-" fl ashes
- and then the 5 key. Station 17 can be heard by
pressing the 1 key followed by the 7 key.
7. For VHF/FM mode pull out the telescopic antenna (5)
and turn it to improve reception. The stereo control
lamp ST in the display only lights up if you have selec-
ted FM stereo and are receiving the station in stereo
quality. In the case of FM stations you can use the
ST./MONO button (27/49) to switch between MONO
and STEREO reception. Where reception is bad we
recommend switching to MONO.
8. An aerial is integrated into the device for the reception
of AM stations. The device can be turned to line it up
with the transmitter. In this frequency band programs
are transmitted in „mono" only.
9. Storage of the stations is deleted as soon as the
mains plug is removed from the socket or in the case
of a power cut if there are no power reserve batteries
inserted.
Playing Cassettes
1. In order to switch the device on please press the
POWER switch (1/36).
2. Now use the FUNCTION button (30/42) to select the
TAPE mode so that you can listen to a cassette.
3. Press the í/ stop/eject button (21) to open the
cassette compartment (18).
4. Insert a recorded audiocassette into the compartment
with the tape opening facing upwards and the side you
wish to listen to facing the front (full spool to the right).
Then close the cassette compartment (19) again.
5. Press the
I /n TUNING/
6. With the í/ stop/eject key you can stop playback.
7. Wind the tape forwards or backwards if necessary in
the direction of the arrow keys
8. Always press the í/ stop/eject key (21) when chan-
ging the direction or stopping the tape. This prevents
damage to the machine and the tape.
9. If the í/ stop/eject button is pressed again the fl ap
of the cassette compartment opens.
PRE-
10. In order to interrupt playback briefl y, press the II pause
button (20). Pressing again continues playback.
PRE-UP or

Cassette Operation

playback key (24) to listen to the tape.
= forwards (22), = reverse (23).
08.07.2005, 9:05:03 Uhr
55