Start-Up Of The Device/Introduction; General Operation - AEG SRR 4308 CD/MP3 Mode D'emploi & Garantie

41 REPEAT button
42 FUNCTION button
43 PRE button (Down)
44 MUTE button
45 Numerical keys (0-9)
46 II CD play/pause button
47 I /n SKIP/TUN button
48 CD stop button
49 FIND/ESP / ST./MO. button
50 RANDOM button
51 PRESET EQ button
52 VOLUME + / - (Volume) buttons
53 PRE button (Up)

Start-up of the device/Introduction

• Please read the operating instructions carefully before
using the radio recorder for the fi rst time!
• Select a suitable location for the radio recorder, such
as a dry, fl at, non-slip surface on which it is easy to
operate the machine.
• Ensure that the radio recorder is suffi ciently ventilated!
Power supply
• Insert the mains plug (e.g. battery compartment (34))
into a correctly installed 230 V, 50 Hz power socket.
Ensure that the voltage is the same as that indicated
on the model identifi cation plate.
• Close the battery compartment, making sure not to
trap the mains lead.
• Please ensure that during mains operation the
POWER switch (31) on the back is turned to AC, and
during battery operation to DC.
• After you have inserted the plug into the socket the
device switches to the STANDBY mode and the control
lamp (2) lights up.
Inserting the Batteries
(not supplied)
• Open the battery compartment (34) on the bottom.
• Insert 8 batteries of type UM2/R14 1,5V. Ensure that
the polarity is correct (see the fl oor of the battery
compartment)!
• Close the battery compartment, making sure not to
trap the mains lead.
• Please turn the POWER switch to DC during battery
operation.
• If you do not use the machine for a prolonged period,
remove the mains plug from the socket and remove the
batteries in order to prevent battery acid from leaking.
54
05-SRR 4308 CD AEG New 54
If there is a power cut or the mains plug has been removed
from the power socket, the settings will be retained if the
power reserve batteries are inserted. Insert 2 micro-batte-
ries of type LR 3 "AAA" 1.5V.
Remote Control Batteries
(not supplied)
• Open the lid of the battery compartment on the back of
the remote control.
• Insert 2 microbatteries of type LR 3 "AAA" 1.5V. Ensure
that the polarity is correct (see the fl oor of the battery
compartment)!
• If the remote control is not used for a prolonged period,
remove the batteries in order to prevent battery acid
leaking.
• Always replace the complete set of batteries. Do not
replace just one battery.
Warning: batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer's.
Never throw batteries into the fi re.
CD deck transport protection
Please open the CD compartment (7) by pressing the
OPEN/CLOSE button (8). Remove the transport protection
from the CD player if present before use.

General Operation

POWER (1/36)
When the device switches to ready-for-operation mode the
control lamp (2) goes off, or the device switches to standby
mode. Unplug the device.
VOLUME (28/52)
This is used to set the individual volume. The letters „VOL"
and a fi gure appear in the display (6). This corresponds
to the volume that has been set as far as „VOL 30" or
„VOLUME 00".
PHONES (33)
When the plug of a set of headphones is inserted into the
headphone socket on the back of the device the loudspea-
kers are switched off. If your plug does not fi t, please use
an appropriate adapter.
BEAT CUT (32)
When recording from AM transmitters there may be
interference from frequency overlays. It may be impossible
to remove these by turning the BEAT CUT switch.
08.07.2005, 9:05:02 Uhr