Oase InScenio EGC Notice D'emploi page 24

Establishing the direct WLAN connection (Access Point)
The smartphone/tablet and the InScenio EGC Controller are directly connected.
• Select the direct connection, if no WLAN network is available, the WLAN router
does not support WPS or the distance between the WLAN router and InScenio EGC
Controller is too long.
Prerequisite:
• The range of the WLAN connection between the smartphone/tablet and InScenio
EGC Controller can span a distance of up to 80 m provided there is unobstructed
signal transmission and there are no sources of interference.
How to proceed:
1. Open the settings on your smartphone/tablet.
2. Activate the WLAN.
3. Select ʺOase EGC Controller xxxxxxʺ from the network list.
– The network name (SSID)
troller.
– The sequence of letters "xxxxxx" in the network name (SSID)
and represents part of the MAC address of the InScenio EGC Controller.
4. Enter the WLAN password.
– The default password
– The factory-set default password is
5. Select "Connect."
– If the connection is successful, "Connected" (Android) or a "" (iOS) will appear
under the network name.
– The connection is encrypted and protected by the password.
– Other WLAN connections are deactivated.
 The direct WLAN connection to the InScenio EGC Controller is established.
24
 is indicated on the label on the InScenio EGC Con-

is indicated on the label on the InScenio EGC Controller.

"oase1234".
iOS Android

is unit-specific
EGC0011