Insert Tools, Accessories; Technical Data - Hilti TE 6-A36 Mode D'emploi

NOTE
Indication of the charge status is not possible while the power tool is in operation or immediately after operation. If the
battery charge status LEDs blink, please refer to the information given in section 9, "Troubleshooting".

3 Insert tools, accessories

en
Designation
Hammer drill bits
Anchor-setting tools
Quick-release chuck for wood and metal drill bits
Keyed chuck
Wood drill bits
Wood drill bits (auger bits)
Metal drill bits (for steel)
Designation
TE‑C CLICK chuck
Charger for Li-ion batteries
Charger for Li-ion batteries
Charger for Li-ion batteries
Charger for Li-ion batteries
Charger for Li-ion batteries
Battery
Battery
Battery
Battery
Battery
Angular chuck
TE DRS‑6‑A dust removal module

4 Technical data

Right of technical changes reserved.
Power tool
Rated voltage (DC voltage)
Weight in accordance with EPTA procedure 01/2003
Dimensions (L x W x H)
Drilling speed without hammering
Hammer drilling speed
Speed under no load in hammer drilling mode
Single impact energy in accordance with EPTA proced-
ure 05/2009
NOTE
The vibration emission level given in this information sheet has been measured in accordance with a standardised test
given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment
18
Description
∅ 5...16 mm
C-type connection end
With smooth shank, hexagonal shank
With smooth shank, hexagonal shank
∅ 3...20 mm
∅ Max. 14 mm
∅ 3...10 mm
Short designation
C 4/36
C 4/36‑ACS
C 4/36-ACS TPS
C 4/36‑90
C 4/36‑350
TE 6‑A36
36 V
4.0 kg
344 mm x 94 mm x 215 mm
1,010/min
940/min
1,040/min
2.0 J
Description
B36/2.4 Li‑ion
B36/2.6 Li‑ion
B36/3.0 Li‑ion
B36/3.3 Li‑ion
B36/3.9 Li‑ion
C-type connection end