Insert Tools, Accessories - Hilti SD 5000 Mode D'emploi

2.8 Items supplied as standard
1 Power tool
1 Chuck (bit holder)
1 Depth gauge
1 Operating instructions
1 Cardboard box
en
1 Belt hook
1 S B PH2 DRY bit
1 S BH 75M bit holder
2.9 Using extension cords
Use only extension cords of a type approved for the application and with conductors of adequate cross section.
The power tool may otherwise loose performance and the extension cord may overheat. Check the extension
cord for damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cable lengths
Conductor cross section
Mains voltage 110-120 V
Mains voltage 220-240 V
Do not use extension cords with 1.25 mm conductor cross section.
2.10 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this
application.
2.11 Using a generator or transformer
This power tool may be powered by a generator or transformer which fulfills the following conditions: The
unit must provide a power output in watts of at least twice the value printed on the type identification plate
on the power tool. The operating voltage must remain within +5% and -15% of the rated voltage at all times,
frequency must be in the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with
automatic voltage regulation and starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching
other power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in
damage to the power tool.

3. Insert tools, accessories

Depth gauge
Depth gauge
Bit holder
Bit holder
Magazine
Magazine
Extension
18
Printed: 07.07.2013 | Doc-Nr: PUB / 5070555 / 000 / 00
1.5 mm 2.0 mm
20 m 30 m
50 m
2.5 mm
40 m
100 m
S DG D 11 x 50 for 50 mm bit holder
S DG D x 11 for 75 mm bit holder
S BH 75M
S BH 50M
SMI 55 plus
SMD 57
SME extension for working on floors and ceilings
3.5 mm
50 m