Displaying Device Details - Carel boss Mode D'emploi

3.5 Displaying device details

Custom settings can be checked after restarting the boss engine. Wait the required amount of time (based
on the parameter recording frequency) to display log data (e.g.: graphs).
Under Installation à Devices, click the confi gured
1.
device.
2.
The Main device detail page is shown.
3.
Click Read-only variables to display the probe table
4.
Open the Parameters page to display all parameters
for the device, divided into groups.
5.
Open the Alarms page to display all the active or
closed alarms relating to the device.
13
ENG
+040000260 - 1.1 - 06.03.2019