Carel boss Mode D'emploi page 39

11.
Under Activities
management à Alarm conditions. Click Add
and enter the name of the alarm condition (e.g.:
"no showcase communication ").
12.
Choose the device and the alarm variable to be
checked.
Click È to add the variable.
13.
14.
Repeat to add the number of variables that need
to be checked.
15.
Click Add: the new condition is added to the list
of conditions.
Warning: the message area shows a notifi cation
requiring the engine to be restarted and the direct
command to do so. This means boss needs to be
restarted to make the changes eff ective.
Note:
•
to set a single rule for all site alarm conditions,
select "All alarms".
•
set a rule for all alarm conditions based on priority,
select the priority to be managed under Priority.
16.
Under Activities
management à Rules enter the name of the
rule (e.g.: "email no showcase communication").
17.
Choose the alarm condition or event (e.g.: "No
showcase communication ").
18.
Choose the time band in which the action is
enabled (e.g.: "dayshift weekdays").
19.
Choose the action (e.g.: "email to service")
20.
Defi ne the delay for the action
21.
Enable the rule
22.
Click Add: the new rule is added to the list.
23.
Click Save.
24.
Restart the engine.
à
Alarm and event
à
Alarm and event
19
ENG
+040000260 - 1.1 - 06.03.2019