After Cleaning; Tools - Hoover MAXExtract Mode D'emploi

tO Clean hard flOOrs (COntinued)
11. When finished cleaning, follow "After cleaning"
instructions on page 12.
Unplug cleaner from electrical outlet and remove
squeegee from nozzle. Rinse it in clear water.
(Reference Figs. 2.13 - 2.17)

after CleaninG

Allow carpet or upholstery to dry. To help prevent
matting and resoiling the carpet, keep children and
pets away from surface until it is completely dry. If it
is necessary to walk on damp carpet, place towels
or white cloths on the traffic areas.
If furniture must be replaced before the carpet is dry,
place plastic or aluminum foil under legs of furniture
so metal slides or wood finishes will not stain the
carpet.
Empty tanks, rinse with clean water and let air dry.
Rinse the Dirty Water Tank lid and let air dry.

4. tOOls

tOOls
4.1
A
b
spinsCrub hand tOOl
®
4.2
(Available on select
models only)
4.2 To remove the
SpinScrub ® hand tool pull
tool up and outward.
To reposition the tool,
reverse this procedure.
Actual model may vary from images shown.
3.5
Filter
Screens
A
IMPORTANT
3.5 To keep performance of your machine at
peak level remove nozzle (Fig. 5.1) and check
filter screens (A) located inside the base of the
unit and remove lint or debris.
A. SpinScrub ® Hand Tool (Available on select
models only) has rotating brush for extra scrubbing
action on small carpet areas, carpeted stairs and
upholstery. For some models, the brushes can
be removed for converting to the scrub module.
(Available on select models only)
B. Stair/Upholstery Nozzle has a built-in brush to
help provide the scrubbing action some spots may
need for removal.
12