Rockinger RO 50 Série Instructions De Montage Et D'utilisation page 26

3 3 . . M M a a i i n n t t e e n n a a n n c c e e
Fig. 12
H
R
1
R
Fig. 13
Check lock of the funnel:
Note: The funnel must be locked in its central position when coupling
is opened to be prepared for coupling on!
x Push the funnel sidewards
x Move handlever in locking direction (up)
x Release funnel
x The funnel must swing back in central position and be locked again
x If not, justify the central position by the lower unit as below.
Adjustment: (s. fig. 13)
M
x Loosen screws (1) and bring the funnel into the central position:
x Open coupling: Funnel lock should be inserted
x Tighten screws (1) – Tightening torque 85 Nm.
x Both ends of torsion spring sides (R) must lie slack free (S) against
x In case there is gap you can close it very easilyby bending the spring
(see fig. 12)
the rib of the funnel. Between the spring holder (H) and the lay-on
points of the torsion springs should also be no gap.
holder with a screwdriver (M) (see fig. (S = 0).
ROCKINGER
Member of JOST-World
R R O O 5 5 0 0
i i
27