Helpful Hints - ThermoPro TP-20 Manuel D'utilisation

Count up
1. Press the MODE button to select the TIMER mode, The timer 00:00 with a small
icon TIMER will be shown in the upper part of the display. If the timer setting is
not 00:00, press and hold S./S./
2. Press the S./S./ /CLEAR button to start count up. The TIMER
indicating count up timer is running. The maximum count up that can be
EN
reached is 99 hours and 59 minutes.
3. To stop the count up process, press the
▲
becomes solid.
4. Press and hold S./S./ /CLEAR
5. When count up timer reaches 59 minutes and 59 seconds, it will
automatically change to Hour: Minute display format.

Helpful Hints

If the receiver and / or the transmitter display LLL or HHH instead of the
probe temperature, wait for probe to reach room temperature. If LLL or HHH
is still displayed or you get a false temperature, squeeze the probe jacks
harder into the transmitter and twist them back and forth so they make good
contact. If the problem still persists, it is likely the internal probe wire has
shorted out either through moisture or heat damage.
Do not immerse the probe in water while cleaning.
Do not allow the probe or probe wire to come into contact with flames.
Within the warranty period return defective probe to address below along
with a return address and we will send you a replacement probe at no charge.
If the temperature displayed seems to read too high or the temperature
seems to increase too quickly, check to make sure the probe tip is not poking
through the food. Reposition the probe tip in the center of the thickest part of
food. Avoid touching bone or heavy fat areas.
Cautions:
1. Always wear a heat resistant glove to touch the stainless steel probe sensors
/CLEAR to clear the setting to 00:00.
▲
will blink
S./S./ /CLEAR button. The
to clear the setting back to 00:00.
-10-
or wires during or just after cooking. Do not touch with bare hands.
2. Keep the stainless steel probe sensors and wires away from children.
3. Clean the stainless steel probes and dry thoroughly after each and every use.
4. Do not use the unit in the rain. It is NOT rain proof.
5. Do not expose the plugs of the stainless steel probes or the plug in holes of
the transmitter to water or any liquid. This will result in a bad connections and
faulty readings.
▲
TIMER
6. Do not expose the receiver or transmitter to direct heat.
7. Do not use stainless steel probes in a microwave oven.
8. The Probe Thermometer registers temperatures as low as 32 ºF (0 ºC) and as
high as 572 ºF (300 ºC). LLL will be displayed below 32 ºF and HHH will be
displayed above 572 ºF. Do not use the stainless probe sensor above 572 ºF.
Doing so will deteriorate the wire.
9. Not Intended for use by persons aged 12 and under.
Cleaning
1. Always wear a heat resistant glove to touch the stainless steel probe sensors
or wires during or just after cooking. Do not touch with bare hands.
2. Keep the stainless steel probe sensors and wires away from children.
3. Wash the metal probe tips with hot soapy water and dry thoroughly.
immerse the probe in water while cleaning.
4. Wipe the transmitter and receiver with damp cloth. Do not immerse either in
water.
FCC Compliance
Information to user
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the users' authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
Do not
-11-
EN