Purchasing Additional Remote Sensors; Hints And Tips; Specifications - ThermoPro TP-60 Mode D'emploi

MAX or MIN record is shown on the LCD display, press
and hold MAX/MIN/Clear for 3 seconds.
4. When either the MAX or MIN record is shown on the LCD
EN
display, press ALL-TIME/24 button once to set the data
record time interval between ALL TIME or 24 hours. Note:
Both ALL TIME and 24 hours represent the time since
you last time manually cleared the history data or battery
installation.

Purchasing Additional Remote Sensors

The model number of the remote sensor for this unit is
TPR60.
Additional sensors may be ordered directly from Amazon or
ThermoPro by contacting our customer service listed below.

Hints and Tips

If the receiver does not connect to the transmitter, try the
following:
Press and hold the CHANNEL/SYNC button on the base
station and then press TX button on the transmitter.
-13-
Relocate the base station and/or the remote unit until
connection is found.
Signals from other electronic devices may cause
interference. Place the base station and receiver away
from these devices.
The transmitter may not function properly in extreme
temperatures due to battery power. Replace the batteries
or the unit will resume proper function in more moderate
weather.

Specifications

1. 433 Mhz transmission frequency.
2. Transmission range up to 200 ft. (range maybe shorter
based on interference present).
3. Indoor Temperature range: -4°F~158°F (-20°C~70°C).
4. Outdoor Temperature range: -58°F~158°F (-50°C~70°C).
5. Humidity range: 10% ~ 99%.
6. Temperature tolerance: +/- 2.0°F (+/- 1.1°C).
7. Humidity tolerance: ±2% from 30% to 80%; ±3% below
30% and above 80%.
-14-
EN