Battery Installation And Setup; Synchronize Remote Sensors With The Base Station - ThermoPro TP-60 Mode D'emploi

TX: Press to send temperature/humidity data to the receiver
manually.
EN

Battery Installation and Setup

1. Remove the two small screws with a small screwdriver
at the back of the remote sensor and the battery
compartment door;
2. Slide the channel selector switch inside the battery
compartment to your desired channel. For the first remote
you may select any channel, for additional remotes select
any unused channel;
3. Insert (2) AAA batteries according to the polarity markings.
Replace the battery compartment cover and screws;
4. Open the battery compartment at the back of the base
station and insert (2) AAA batteries according to the
polarity markings. Replace the compartment door;
5. Press the °F /°C button at the back of the base station
to display the temperature in °F or °C.
Note:
Do not mix old and new batteries.
-9-
Do not mix alkaline, standard (carbon zinc), or rechargeable
(nickel cadmium) batteries.
For maximum performance in normal conditions we
recommend using good quality alkaline batteries.
If the battery power is low, there will be low battery icon
showing on the base station display.

Synchronize Remote Sensors with The Base Station

1. Position the remote sensor near the base station;
2. Once the batteries are installed in the base station, the
RF signal icon . (located on the upper left of the base
station display) will flash for 3 minutes, indicating that
the base station is in synchronization mode: it is waiting
for remote sensors to be registered.
3. If 3 minutes have passed after the batteries were installed
in the base station and the RF signal Icon is
flashing, press and hold the CHANNEL/SYNC button
on the back of the base station for 3-4 seconds until the
RF signal icon is flashing again to set it back in
synchronization mode;
no longer
-10-
EN