Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
NOTE:
1. Do not pinch the power supply cord or the flexible gas conduit between the range and the wall.
2. Do not seal the range to the side cabinets.
3. 24" (61 cm) minimum clearance between the cooktop and the bottom of the cabinet when
the bottom of wood or metal cabinet
is protected by not less than ¼" (0,64
cm) flame retardant millboard covered
with not less than No. 28 MSG sheet
metal, 0,015"(0,4 mm) stainless steel,
0,024"(0,6 mm) aluminum, or 0,020"
(0,5 mm) copper.
30" (76,2 cm) minimum clearance when
the cabinet is unprotected.
4. For cutouts below 22 7/8"(58,1 cm),
appliance will slightly show out of the
cabinet.
5. Allow at least 19 ¼" (48,9 cm) clearance
for door depth when it is open.
* IMPORTANT:
To avoid cooktop breakage for cutout width (E dimension) of more than
30 1/16" (76,4 cm), make sure the appliance is centered in the counter opening while
pushing into it. Raise leveling legs and the rear adjustable wheels at a higher position
than the cabinet height (see page 3), insert the appliance in the counter and then level.
Make sure the unit is supported by the leveling legs at the front and the
wheels at the back and NOT by the cooktop itself.
A. HEIGHT
B. WIDTH
35 5/8" (90.5 cm)
30" (76,2 cm)
- 36 5/8" (93 cm)
(Models with Sealed Top Burners)
Door Open
(see note 5)
C. COOKTOP
D. DEPTH TO
WIDTH
FRONT OF RANGE
31½" (80 cm)
28 5/16" (71,9 cm)
B
FRONT
OF
CABINET
E. CUTOUT WIDTH*
(Countertop and
Cabinet)
30±1/16" (76,2±0,15 cm)
21 3/4" (55,2 cm) Min.
22 1/8" (56,2 cm) Max
24" (61 cm) Min. with
2
C
A
D
Side panel
22 7/8" (58,1 cm) min.
23 1/4" (59,05 cm) max.
(see Note 4)
1 1/8"
(2,86 cm)
F
Ref.
F. CUTOUT
G. HEIGHT
DEPTH
OF COUNTERTOP
36 5/8" (93 cm) Max.
35 3/4" (90.8 cm)
Min.
backguard
Figure 1
Publicité
Table des Matières
