Maintenance; Emptying The Dust Cup; Cleaning The Filters - shark NZ801EUT Mode D'emploi

MAINTENANCE

To keep your vacuum's
suction power optimal,
follow these instructions.
Make sure unit is off and
cord is unplugged.
WARNING: To reduce
the risk of shock and
unintended operation,
turn power off and
unplug unit before
servicing�
Hand wash with
water only to prevent
damage from
cleaning chemicals�
Allow ALL filters
to dry completely
before replacing
in the vacuum to
prevent liquid from
being drawn into
electric parts�
IMPORTANT: Do not
use soap when cleaning
the filter.

EMPTYING THE DUST CUP

RECOMMENDED
1
Pull up on dust-cup
FILTER CLEANING
release latch and lift
SCHEDULE:
dust cup off pod.
Pre-Motor Filter Kit
(Foam & Felt)
Clean every 3 months.
Post-Motor Filter
Clean once a year.
15
s h a r kc l e a n . e u
STEP 1 STEP 2
2 Hold dust cup over
a trash bin and press
the bottom dust-cup
empty latch.
STEP 3
FOAM FILTER
FILTER FRAME
FELT FILTER

CLEANING THE FILTERS

1 Pre-Motor
3 Press top dust-cup
(foam and felt):
empty latch to access
dust screen and With the dust cup
removed, take out the
remove built-up debris
foam and felt filters,
as required.
and rinse with water.
Tap loose dirt off
filters between washes
as needed.
2 Post-Motor:
To access the filter,
reach under the grill,
press the button, and
pull the grill away from
the vacuum.
PRE-MOTOR
POST-MOTOR
POST MOTOR FILTER
NOTE: To remove the post-motor foam
filter, pull out from frame.
To remove the
Pre-motor filter, simply
pull black foam out
from frame. Rinse both
filters and allow to air
dry completely before
replacing. Hand wash
only. Replace foam
back into the filter
frame and make sure
edges are tucked into
the frame then insert
back into vacuum.
16
s h a r kc l e a n . e u