Assembling Your Vacuum - shark NZ801EUT Mode D'emploi

ASSEMBLING
YOUR VACUUM
TIP: Push hose clip
into back of wand for
convenience.
TIP: For quick cord
access, rotate upper
hook down and
remove cord.
TIP: Use cord clip
located on the side of
wand to hold cord in
place while vacuuming.
1 Place motorised floor
nozzle on floor and
insert wand, pressing it
in until it clicks securely
into place.
7
s h a r kc l e a n . e u
STEP 1 STEP 2
2 Insert handle into
wand, pressing it
in until it clicks
securely into place.
STEP 3
3 Place pod onto 4 Connect hose into
wand and slide back of pod, pressing it
down to connect. in until it clicks securely
into place.
STEP 4 STEP 5
5 Store included
accessories on
the accessory
posts on the pod.
s h a r kc l e a n . e u
8