Mounting Applications; Workbench Permanent Attachment; Temporary Mounting Using Clamps; Alternate Attachment - Bosch GCM12SD Consignes De Fonctionnement/Sécurité

BM 2610007877 04-10:BM 2610007877 04-10.qxp 4/26/10 8:13 AM Page 27

Workbench permanent Attachment

1. Each of the four mounting holes should be bolted
securely using 5/16" bolts, lock washers and hex
nuts (not included).
2. Locate and mark where the saw is to be mounted.
3. Drill four 5/16" diameter holes through work-
bench.
4. Place the miter saw on the workbench, aligning
holes in base with holes drilled in workbench.
Install bolts, lock washers and hex nuts.

Alternate Attachment

The smaller mounting holes at each corner can be
used for nails or longer drywall screws.
The supporting surface where the saw is to be
mounted should be examined carefully after
mounting to ensure that no movement can occur
during use. If any tipping or walking is noted, secure
the workbench or stand before operating the miter
saw.
CAUTION
could crack foot or damage base.
Rear
Mounting
Holes
Nail Hole
figure 28. Workbench Mounting
Transporting and Mounting

Mounting Applications

Be careful not to over-drive nail
or over-torque the bolt. This
Bolt Hole

Temporary Mounting Using Clamps

If necessary, clamp the miter saw to a workbench
l
or table top.
Place two or more "C" clamps on the clamping
l
areas and secure (see Figure 29). There are
clamping areas at all four corners of the saw.
Be careful not to place clamps over the base
l
extension clamping levers (see Figure 29).
Mounting with clamps may prevent access to
l
some wide miter angles.
Clamping Area
Clamping Area
figure 29. Temporary Mounting Using Clamps
27.