Automatic Charging; Low Battery (Lo) - Samsung POWERbot VR2AR72 Série Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Steps to take if recharging not occuring:
Check the installation status of the
docking station when:
fthe docking station is located in a place where
the POWERbot cannot easily access it.
fthe distance between the docking station and
POWERbot is over 16.4 ft (5 m).
– It may take a long time for POWERbot to
return to the docking station for recharging
1_VR7200_EN_DJ68-00827B-00_AA.indd 13

Automatic charging

Recharging

Low battery (Lo)

ENGLISH-13
When the battery indicator blinks during
cleaning, the POWERbot will return
to the docking station to charge itself
automatically.
You can command the POWERbot to
recharge at the docking station while it is in
cleaning.
Manually charge the POWERbot by placing
it on the docking station.
Manually charge the POWERbot when:
fthe docking station is located in a corner
fthe battery is fully exhausted
fthe POWERbot is immobilized by an obstacle
(furniture etc.)
fthe POWERbot can't climb a threshold near
the docking station (The maximum height of
a threshold the POWERbot can climb is about
0.6 in (1.5 cm)).
fwhen the battery indicator blinks and "Lo" is
displayed
fwhen the POWERbot is set to the Spot clean or
Manual clean mode
2019-03-19 오후 5:25:25

Publicité

Table des Matières
loading

Table des Matières