Automatic Charging; Low Battery (Lo) - Samsung POWERbot SR20J925 Série Manuel D'utilisation

Steps to take if recharging is not being executed
Check the installation status of the
charger when:
fcharger is located in a place where POWERbot
cannot easily access
fdistance of the charger and POWERbot is over 5 m
apart
– It may take a long time for POWERbot to return to
the charger for recharging

automatic charging

recharging

Low battery (Lo)

ENGLISH-11
When the battery indicator blinks
during cleaning, poWerbot will
return to the charger to charge itself
automatically.
you may command poWerbot to
recharge at the charger while it is in
cleaning process.
manually charge poWerbot by
placing it on the charger.
manually charge poWerbot when:
fcharger is located in a corner
fbattery is fully exhausted
fPOWERbot is stuck by obstacles (furniture etc.)
fPOWERbot can't climb threshold near charger
(Height of the threshold that POWERbot can climb:
about 1.5 cm and below)
fBattery indicator blinks and "Lo" is displayed
fPOWERbot is set on Spot clean or Manual clean
mode