Troubleshooting Guide - EINHELL GC-LC 1815 T Mode D'emploi D'origine

11. Troubleshooting guide

Danger!
Before troubleshooting, switch off the equipment and remove the battery.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem
if your equipment fails to work properly. If the problem still persists after working through the list, please
contact your nearest service workshop.
Fault
Chainsaw does not
work at all
Chainsaw operates
intermittently
Saw chain is dry
Chain/guide bar
is hot
Chainsaw judders,
vibrates or does not
saw properly
Anl_GC_LC_1815_T_SPK7.indb 27 Anl_GC_LC_1815_T_SPK7.indb 27
GB
Possible cause
- Battery empty
- Battery is not correctly inserted
- Loose connection (external)
- Loose connection (internal)
- ON/OFF switch defective
- No oil in the tank
- Vent in the oil tank cap is blocked
- Oil outlet is blocked
- No oil in the tank
- Vent in the oil tank cap is blocked
- Oil outlet is blocked
- Chain is blunt
- Chain is overtensioned
- Chain is undertensioned
- Chain is blunt
- Chain is worn
- Saw teeth point in the wrong direc-
tion
- 27 -
Remedy
- Charge battery
- Remove battery and insert again
(see 5.5)
- Consult a specialist workshop.
- Consult a specialist workshop.
- Consult a specialist workshop.
- Top up with oil
- Clean the oil tank cap
- Clear the oil outlet
- Top up with oil
- Clean the oil tank cap
- Clear the oil outlet
- Re-sharpen or replace the chain
- Check the chain tension
- Adjust the chain tension
- Re-sharpen or replace the chain
- Replace the chain
- Refi t the chain with the teeth facing
in the correct direction
30.06.2017 10:38:09 30.06.2017 10:38:09