Installation Of Eyepieces; Installation Of Objectives - Leica Microsystems DMI3000 B Mode D'emploi

6.6 Installation of Eyepieces

The eyepieces are inserted into the eyepiece
tubes.
Note:
We recommend running a teach-in via the Leica
Application Suite (LAS) software when using
eyepieces not included in the scope of delivery.
This will ensure that the total magnifi cation
shown on the LeicaScreen is correct.
Fig. 44 Eyepieces
Fig. 45a Objective turret

6.7 Installation of Objectives

The positions in the objective turret disk are num-
bered (Fig. 45). Depending on your equipment,
the individual objectives have already been as-
signed to specifi c positions at the factory.
For details on the exact positions of the objec-
tives, please refer to the enclosed identifi cation
sheet.
!
Caution:
Close vacant threads in the nosepiece with dust
protection caps!
Please note that the front lenses of the objectives
point upward and are therefore more vulnerable
to contamination than those of upright micro-
scopes.
Check the front lenses for cleanliness frequently.
Note:
Leica DMI6000 B:
We recommend running a parfocality compen-
sation via the Leica Application Suite (LAS) soft-
ware.
Fig. 45b Objective turret, loaded
6. Assembly
43