Firmware - ELSA LANCOM Wireless L-2 Manuel De L'utilisateur

R38 Description of the menu options
Protocol-list
Protocol mode
Node ID
Spare-heap

Firmware

This menu allows you to display various firmware parameters and to initiate a firmware
upload:
/Firmware
Version-table
Table-firmsafe
Mode-firmsafe
Timeout-firmesafe
Test-firmware
Firmware-upload
Version table The version table displays the firmware version and serial number of the device.
Ifc
Ifc
ELSA LANCOM Wireless
This list permits data packets to be blocked or permitted (depending
on the positive/negative setting of the switch) on the basis of their
protocol.
Every Ethernet frame contains a 16-bit identifier stating the Layer-3
protocol of its data. These can be entered in the list as hexadecimal
numbers.
Common protocols include:
0800 = IP
0806 = IP/ARP
8137 = IPX F0F0,
E0E0 = IPX
In this case as well, traffic is blocked between WLAN stations and the
LAN or WAN, but not between the WLAN stations themselves. See
protocol table in the Appendix
Positive/negative switch for the protocol list
MAC layer address of the device
Buffers that receive data packets from the local network
Module
LANCOM Wireless 4100
Display and keyboard settings
Displays hardware releases and serial numbers for the router
Information on the two firmware versions stored in the device
and on the bootloader.
Firmware activation mode
Time in minutes required to test new firmware
Tests the inactive firmware
Initiates a firmware upload
Version
1.60.0012 / 30.06.1999
Serial number
8427.000.020