Status/Lan-Statistics - ELSA LANCOM Wireless L-2 Manuel De L'utilisateur

LAN-tx-bytes and Data volume transmitted from or to this station.
LAN-rx-bytes
State Can be either 'None', 'Auth' or 'Assoc'.
When logging on, a station first authenticates itself, then it 'associates' itself, i.e.
makes itself available for data communications.
The base port will to transfer data without the 'Assoc' status!
'Auth' indicates whether the station replies to an authentication on the part of
the base port.
Encaps. Ethernet frames can be encapsulated in a variety of ways in a WLAN frame.
In the 'IEEE' method, a new header is prepended to the complete Ethernet packet.
A different method uses a more intelligent process in which the headers are con-
verted in one another and 'LLC-SNAP' coding is applied to identify the protocol.
The base port automatically recognizes both coding forms. If the choice is availa-
ble, select SNAP coding, as the overhead per frame is 6 bytes lower.

Status/LAN-statistics

Similarly to the previous menu option, this option allows you to display the statistics
relating to the LAN port. The Status/LAN-statistics menu has the following layout:
/LAN-statistics
LAN-rx-packets
LAN-tx-packets
LAN-rx-errors
LAN-tx-errors
LAN-stack-errors
LAN-NIC-errors
LAN-heap-packets
LAN-queue-packets
LAN-queue-errors
LAN-collisions
Connection
-established
Negotiation
-complete
Connect
LAN-rx-bytes
LAN-tx-bytes
LAN-rx-broadcasts
Description of the menu options
Running status displays
Number of data packets received
Number of data packets sent
Number of data packets incorrectly received
Number of data packets incorrectly sent
Number of packets without a suitable receive module (bridge/
router)
Number of data packets discarded by the NIC
Number of buffers available
Number of buffers in use
Number of packets discarded due to a lack of buffers
Number of collisions during a send procedure
Display of correct Ethernet connection (data transfer possible).
Corresponds to the 'Link' LED on the device.
The negotiation of the transfer mode between the router and
the remote station is complete.
This is only relevant if Setup/LAN/Connection is set to 'Auto'.
The preselected LAN connection is fixed at 10Base-T. See
Setup/LAN-/connection.
Number of bytes received from the LAN
Number of bytes sent to the LAN
Number of broadcast packets received from the LAN
ELSA LANCOM Wireless
R21