Status/Delete-Values; Setup - ELSA LANCOM Wireless L-2 Manuel De L'utilisateur

R28 Description of the menu options

Status/Delete-values

With the exception of the tables, this option allows you to delete all the values in the
substatistics. To do so, enter the following command:
do delete-values

Setup

This menu allows you to query and modify all the system parameters that are necessary
to the functioning of the devices.
/Setup
Name
LAN-module
TCP-IP-module
SNMP-module
DHCP-module
WLAN-module
Config-module
Name
Here you can enter the device name (maximum 16 characters). The set of characters
available includes uppercase and lowercase letters as well as some special characters.
You can display the full range of available characters during a configuration session by
entering the following command:
set \setup\nname ?
In the default configuration, no name is entered.
The device name is required for identification purposes; it is a prerequisite for any
connection via the IPX or IP router module, since the routers can exchange data only with
known remote stations, and is also required for the unambiguous identification of a
remote bridge station.
In the case of PPP connections, either the user name with the password from the PPP list
or the device name is transferred to the remote station as a device ID during a verification
by PAP or CHAP.
Since the router permits only upper case letters in the device name list, the name is
transferred in uppercase letters in the case of a verification by the ELSA protocol. Special
characters should not be used in device names unless the remote station can process
them.
ELSA LANCOM Wireless
System configuration
Entering the device name
LAN settings
TCP/IP module settings
Settings for configuration via SNMP
DHCP server settings
Wireless network settings
Configuration module settings