English; Safety Information | Specified Conditions Of Use | User Groups | Care And Maintenance | Warranty | Technical Data | Symbols | Original Declaration Of Conformity - Weller Zero Smog TL Traduction De La Notice Originale

Masquer les pouces Voir aussi pour Zero Smog TL:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
Read these instructions and the
accompanying safety information
carefully before starting up the
device and starting work with the device.
Keep these instructions in a place that is accessible to all
users.
Safety information
This appliance can be used by
children aged from 8 years and
above and persons with reduced
physical, sensory or mental capa-
bilities or lack of experience and
knowledge if they have been given
supervision or instruction concer-
ning use of the appliance in a safe
way and understand the hazards in-
volved. Children shall not play with
the appliance.
Cleaning and user maintenance
shall not be made by children wit-
hout supervision.
WARNING Electrical shock
If the device is faulty, active electrical conduc-
tors may be bare or the PE conductor may not be
functional.
Repairs must always be referred to a Weller-trained
specialist.
‚If the electrical tool''s power supply cord is damaged, this
must be replaced with a specially prefabricated power
supply cord available through the customer service
organisation.'
WARNING Danger of injury
The device or parts of the device may fall off during
transportation.
WARNING Danger of asphyxiation, Danger of
poisoning
Improper installation can result in above-normal
workplace concentrations
Measure the workplace concentration upon completion
of installation work
Inappropriate maintenance cycles for gas media
may result in above-normal workplace concentra-
tions
Specify maintenance cycle
Above-normal contamination levels in the ambient
air during cleaning work on the pipe system/extrac-
tion area
If suction capacity is impaired by build-up within the
pipe system, replace the contaminated parts
A saturated activated carbon filter will not be able
to capture harmful substances. The harmful subs-
tances will be released back into the environment
unfiltered.
Observe the recommended filter replacement
intervals.
High concentrations of harmful gases can lead to
overheating of the activated carbon and possibly
trigger spontaneous combustion of the filter.
Run the unit on clean air for several minutes before
switching off.
Specified Conditions Of Use
This filtration system is suitable for the extraction and
filtration of particles and gases, depending on the filter
medium used.
This device may only be used at room temperature
and indoors.
The unit is designed for use as a surface extraction
unit and is not suitable for extracting fumes directly
from the soldering gun.
Soldering or welding enamelled wire
For soldering and welding enamelled wire, use the
standard prefilter F7.
Extraction of adhesive vapours
Use a broadband gas filter (without a suspended
matter filter) for the extraction of adhesive vapours.
Danger of asphyxiation, Danger of
WARNING
poisoning
Improper use may result in respiratory problems,
asphyxiation, poisoning or cancer
Particles and gases which are unsuitable for the filter
medium in use may not be extracted.
Liquids and flammable gases may not be extracted
Never use the device without a filter or with a full filter.
Never use the device without the fan cover
GB

ENGLISH

15

Publicité

Table des Matières
loading

Table des Matières