Configuring For The Sgi Environment - Seagate DAT Drive DDS Manuel D'installation

A-32 Seagate DAT Drive Installation Manual—English
tape-config-list=
"ARCHIVE Python PRTNO-XXX","Seagate DAT
Drive","SEAGATE_DAT";
SEAGATE_DAT =
1,0x2c,0,0xd639,4,0x00,0x8C,0x8C,0x8C,3;
Note: The inquiry string above contains one space
between Python and PRTNO. See the beginning of this
chapter for information on replacing PRTNO with the
number applicable to your drive.
Once st.conf has been modified, the kernel must be
reconfigured by booting the system using the boot -r
command

Configuring for the SGI Environment

Irix V5.x
To configure Irix 5.x to use the Scorpion-24, you must modify
the file /var/sysgen/master.d/scsi as described below:
1. Add the following entry to the file
/var/sysgen/master.d/scsi.
{DATTAPE,TPDAT,7,12,"ARCHIVE","Python
PRTNO"/*DAT*/,0,0,{0,0,0,0},
MTCAN_BSF|MTCAN_BSR|MTCAN_APPEND|MTCAN_SETMK|MTCA
N_PART|MTCAN_PREV|
MTCAN_SYNC|MTCAN_SPEOD|MTCAN_CHKRDY|MTCAN_VAR|MTC
AN_SETSZ|
MTCAN_SILI|MTCAN_SEEK|MTCAN_CHTYPEANY,
/* minimum delay on i/o is 12 minutes, to allow
the Drives
* full error recovery sequence to be
performed. */
40, 12*60, 12*60, 12*60, 512, 512*512 },
2. Rebuild the kernel, as described below.