Seagate DAT Drive DDS Manuel D'installation page 16

A-14 Seagate DAT Drive Installation Manual—English
Mounting the drive in a 5.25-inch drive bay
If you are mounting the drive in a 5.25-inch drive bay, you
must use a drive with mounting brackets. As shown in Figure
5 below, the 5.25-inch drive brackets have four screw holes
on the bottom and six on each side.
Figure 5
Mounting holes for internal DAT drive in 5.25-inch
configuration (with mounting brackets)
41.3 mm
(1.63 in)
41.2 mm
(1.62 in)
Side View
9.9 mm
(.39 in)
2 PLACES
21.8 mm
(.86 in)
2 PLACES
31.5 mm
(1.24 in)
2 PLACES
M3.0 X
4 DEEP MIN.
M3.0 X
4 PLACES
4 DEEP MIN.
12 PLACES
79.4 mm
(3.13 in)
180.6 mm
2 PLACES
(7.11 in)
47.6 mm
(1.87 in)
2 PLACES
6 mm
(.24 in)
Bottom View
2 PLACES
146 mm
(5.74 in)
139.7 mm
(5.50 in)
79.4 mm
(3.13 in)
47.6 mm
(1.87 in)
148.5 mm
(5.84 in)