Seagate DAT Drive DDS Manuel D'installation page 26

A-24 Seagate DAT Drive Installation Manual—English
Note: External DAT drives also contain a round, green
power-on LED on the front panel.
Figure 12
Status LEDs on front of drive
Internal
DAT drive
External
DAT drive
Power
LED
Drive status LED
The Drive Status LED is yellow and indicates the following
conditions:
If the Drive Status light is ON continuously, the drive is
reading or writing the tape (that is, SCSI or DAT activity is
present). If you push the eject button while the Drive Status
LED is ON, you may lose data.
Note: If a SCSI Prevent Media Removal command has
been issued, the Drive Status LED remains ON until the
command is canceled.
If the drive status light is flashing rapidly, a hardware fault
has occurred. If this occurs immediately after power-on and
you have enabled the power-on self-test (through a jumper
Cassette Insertion Slot
Cartridge
Drive
Status LED
Status LED
(green)
(yellow)
Cassette Insertion Slot