2Set Language; 3Selection Of The Serial Communication Port - Videotec SM328A Manuel D'instructions

The following is therefore necessary:
1. key in the old password (if the password does not exist, the field must be left empty)
2. key in the new password
3. key in the new password again to make sure it was keyed in properly the first time
Confirm by clicking on the "OK" button. The next time the program is launched the new program will be
requested.
Note that to disable the password it is sufficient to insert a new empty password.
8.2.3.2 Set language
The program gives a choice of languages from the user interface. To set the required language, select the
"Language" option from the menu and then click on the language required (see figure 11).
figure 10: languages
8.2.3.3 Selection of the serial communication port
One of the features of the software setup is that the data contained in the configuration file is transmitted to
the matrix through the serial port. The program uses serial port COM 1 by default. It is however possible to
change its setting:
1. Select the option "Preferences>COM Port" from the main menu
Illustration 8.2.1: Main menu
2. A linked menu containing the list of serial ports will appear. Select the required port.
Illustration 8.2.2: Main menu
3. A tick will indicate the serial port is being used.
•
8. Configuration software Page 48/66 MNVCSM328A_1511_EN