System Installation; Preliminary Operations; Opening The Package; Checking The Markings - Videotec SM328A Manuel D'instructions

2

SYSTEM INSTALLATION

2.1

Preliminary operations

2.1.1

Opening the package

When the product is delivered make sure the package is intact and has no obvious signs of dropping,
scrapes or scratches. If the package is damaged or if there is something missing from the following list,
contact the supplier immediately.
Material supplied with the matrix should be as follows:
•
1 programmable SM328A video matrix
•
1 user's manual
•
1 wide range power supply, IN 100-240VAC 50/60Hz, OUT 12VDC, including cables
•
2 DB25 connectors complete with shell
•
1 serial 9-pin cable
•
CDROM with setup software
2.1.2

Checking the markings

The base of the matrix has a label that complies with CE markings, containing:
•
Product identification code
•
Power supply voltage (Volts)
•
Frequency (Hertz)
•
Maximum consumption (Watts)
Before proceeding with the installation, examine the marking labels to make sure the supplied material
corresponds with the required specifications. Do not, for any reason, make changes or connections unless
indicated by this manual: using unsuitable equipment may constitute a serious safety hazard for people
and for the system.
2.1.3

Switching on and off

Before powering the appliance:
•
Examine the marking labels to make sure the supplied material corresponds with the required
specifications.
•
Make sure the matrix and other components in the system are closed up properly so that the direct
contact with operating devices is impossible, except for the installation procedure otherwise required: in
this case proceed with great care, following the instructions given in this manual.
•
the matrix and the other parts of the system should rest on a large, solid base.
•
The power supply and connecting cables should not hamper the installer technician and operators when
carrying out normal operations.
•
Make sure the power outlet and extension cables, if any, are sufficient for the power load required by
the system.
If in doubt, always consider the system on.
2.1.3.1 Switching on
Plug the power supply into the power outlet and connect the corresponding jack to the matrix
connector labelled 12VDC. Turn the switcher on ON (I) position.The LED on the front of the matrix should
light up.
•
2. System installation Page 7/66 MNVCSM328A_1511_EN