GB UNI-ALL Mode D'emploi page 55

Table des Matières

Publicité

CHANGE TO GROUP 2/3 (15 – 36 KG)
Release the car seat from the base.
Store the harness system of the car seat in the designat-
ed areas by following the below mentioned steps:
• Loosen the shoulder belts (18) by pressing the cen-
tral adjuster (19) and pull both shoulder belts out as
far as you can.
• Bring the headrest in to the highest position possible.
• Open the belt buckle (20) by pressing the red button.
• Detach the belt pads (27) from the shoulder belts, hip
belts and belt buckle.
• Pull up the cover in the sitting area until the storage
compartment for the harness buckle can be accessed.
• Now pull the harness buckle through the seat cover.
• Open the cover of the storage compartment (28) and
place the belt buckle (20) inside.
• Close the storage compartment.
• Store away the buckle tongues (22) in the designated
recess (29) in the backrest.
• Re-apply the seat cover.
NOTE! The car seat cannot be switched to group 2/3
position before the belt buckle and the harness tongues
have been stowed in their storage compartment.
MODIFICA AL GRUPPO 2/3 (15–36 KG)
Posizionare il seggiolino dalla base
Conservare il sistema di cinture del seggiolino per auto
nelle aree designate seguendo i passaggi indicati di
seguito:
• Allentare le cinture per le spalle (18) premendo il siste-
ma di regolazione centrale (19) e tirando entrambe le
cinture per le spalle il più lontano possibile.
• Portare il poggiatesta nella posizione più alta possibile.
• Aprire la fibbia (20) premendo sul pulsante rosso.
• Staccare le imbottiture della cintura (27) dalle cintu-
re per le spalle, dalle cinture per i fianchi e dalla fibbia
della cintura.
• Sollevare la copertura nella zona di seduta
fino a quando il vano di stoccaggio della fibbia
dell'imbracatura diventa accessibile.
• Ora far passare la fibbia dell'imbragatura attraver-
so la fodera del sedile.
• Aprire il coperchio del vano portaoggetti (28) e
collocare la fibbia della cintura (20) all'interno.
• Chiudere il vano portaoggetti.
• Riporre le linguette della fibbia (22) nel vano
apposito (29) nello schienale.
• Rimettere la copertura del sedile.
NOTA BENE! Il seggiolino per auto non può essere
scambiato nella posizione del gruppo 2/3 prima che la
fibbia e le linguette delle cinghie non siano state riposte
nel vano portaoggetti.
55

Publicité

Table des Matières
loading

Table des Matières