Potential Faults - Schluter Systems LIPROTEC-EASY Mode D'emploi

6.2 Potential faults

Fault description
LED modules do not
light up
62
Cause
Power socket not supplied
with mains voltage
Power supply not connected Connect the power supply to the
Switchable socket switched
off
Power supply faulty
Not all plug connectors are
connected
LED modules switched off
via Bluetooth receiver
Power supply overloaded
Bluetooth receiver faulty
Basic requirements for
installation not met
Moisture has penetrated live
system components or plug
connections
Plug connector does not
fully click into place
Remedy
Have the power socket connect-
ed by a qualified electrician.
LED module.
Switch on the switchable socket.
Replace the power supply with
a new one. Do not attempt to
repair it yourself!
Connect all plug connectors
» "Connecting components
13 14
electrically » + " on
page 57.
Switch them on via radio remote
control or Schlüter -LED-Color-
®
Control app.
Use a power supply with
sufficient power » "Technical
data for the power supply" on
page 65.
Replace the Bluetooth receiver.
Give due consideration to the
basic requirements for installa-
tion » "Installation requirements"
on page 51
Leave all system components to
dry, ensure that they have dried
off completely and permanently
prevent any repeat of water pen-
etration. Replace any damaged
components with new ones.
Establish all intended plug con-
nections. Ensure that the plug
connectors fully click into place.