Schluter Systems LIPROTEC-EASY Mode D'emploi page 44

LIPROTEC-P Operating Instructions
DANGER!
Danger to life due to electric shocks!
The power supply operates with 230 V mains voltage on the input side.
Contact with live parts can cause fatal electric shocks.
– Never open the power supply.
– Never cut through the mains cable or remove it from the power supply.
– Only use the power supply included in the delivery or a power supply
listed in these operating instructions.
– Only connect the system components listed in these instructions to the
power supply.
– Work on permanently or temporarily live components (e.g. power sock-
et) must only be carried out by qualified electricians who are authorised
to perform such work at the place of use.
WARNING!
Danger of death and injury for children and infants!
Some system components are so small that children can swallow them
and choke on them. Children can strangle themselves on the attached
cables. If children swallow the special adhesive or the battery of the radio
remote control, this may result in poisoning.
– Keep all system components of the LED system out of reach of chil-
dren and infants.
WARNING!
Risk of fire, injury and poisoning due to improper
handling of the special adhesive!
The special adhesive is flammable. If it burns, toxic fumes are produced
which can cause damage to health if inhaled. If the adhesive gets on the
skin, this may cause skin irritation. If the adhesive is swallowed, this may
cause poisoning.
– Never burn off adhesive or adhesive residue.
– Always wear gloves when applying adhesive.
– Do not eat during adhesion.
– Remove adhesive residue immediately after adhesion.
EN
47